Westermo U200 Operator manal Manuel d'utilisateur

V4.5 www.westermo.com U/R/T200 series - 1 - U/R/T200 series Operator Manual

V4.5 www.westermo.com U/R/T200 series - 10 - switch engine will drop packets. Packet re-transmission is then required and must be handled by t

V4.5 www.westermo.com U/R/T200 series - 11 - Pair 2 RD + pin 3 <-------> Pin 1 TD + RD - pin 6 <-------> Pin 2 TD -

V4.5 www.westermo.com U/R/T200 series - 12 - Figure 3, FX connector types 4.7.2 Fibre Optic Parameters Parameters that have relevance for f

V4.5 www.westermo.com U/R/T200 series - 13 - 5 Power Supply Connector 5.1 Redundant power inputs The switch is designed to operate permanentl

V4.5 www.westermo.com U/R/T200 series - 14 - 5.3 Power Supply & Fault Contact Connection Diagram Power supply connection terminals +VinA

V4.5 www.westermo.com U/R/T200 series - 15 - Figure 6, Power and fault contact – connection diagram 2 Example circuit 1, see Figure 5, will

V4.5 www.westermo.com U/R/T200 series - 16 - Figure 7, Power and fault contact – connection diagram 3

V4.5 www.westermo.com U/R/T200 series - 17 - 6 Deterministic Ethernet - QoS 6.1 Principles of Deterministic Ethernet Westermo OnTime switch

V4.5 www.westermo.com U/R/T200 series - 18 - 6.3 Layer 3 priority Each IPv4 header contains a ToS field, see figure below. The switch is config

V4.5 www.westermo.com U/R/T200 series - 19 - 7 Fast Re-configuration of Network Topology (FRNT) 7.1 Introduction The Westermo OnTime 200 ser

V4.5 www.westermo.com U/R/T200 series - 2 - 1 INTRODUCTION...

V4.5 www.westermo.com U/R/T200 series - 20 - Figure 10, FRNT version 0, single ring topology 7.2.2 FRNT version 0, configuration rules The

V4.5 www.westermo.com U/R/T200 series - 21 - The communication media between the two FRNT version 0 rings may not be under direct control of th

V4.5 www.westermo.com U/R/T200 series - 22 - 8 Rapid Spanning Tree Protocol (RSTP) The R/T200 switch series supports the Rapid Spanning Tree

V4.5 www.westermo.com U/R/T200 series - 23 - received on the root port of the switch, the switch also forwards it with an updated message to al

V4.5 www.westermo.com U/R/T200 series - 24 - The typical time it takes to enter forwarding state from blocking state or vica versa (i.e. the ne

V4.5 www.westermo.com U/R/T200 series - 25 - 9 Simple Network Management Protocol (SNMP) The Westermo OnTime R/T200 switch supports Simple N

V4.5 www.westermo.com U/R/T200 series - 26 - • MIB-2 Transmission Control Protocol Group (TCP) , RFC1213-MIB, OID: 1.3.6.1.2.1.6. Contains inf

V4.5 www.westermo.com U/R/T200 series - 27 - • Temperature alarm configuration • SNMP host addresses 9.2 SNMP Traps One feature of SNMP is

V4.5 www.westermo.com U/R/T200 series - 28 - 10 IGMP snooping 10.1 IP Multicast filtering Several applications are based on multicast comm

V4.5 www.westermo.com U/R/T200 series - 29 - measurements reports according to IGMP v2. IP multicast producers are not required to make an IGM

V4.5 www.westermo.com U/R/T200 series - 3 - 8 RAPID SPANNING TREE PROTOCOL (RSTP) ...

V4.5 www.westermo.com U/R/T200 series - 30 - 11 VLAN A physical Ethernet network can be divided into several overlapping Virtual LANs (VLAN)

V4.5 www.westermo.com U/R/T200 series - 31 - Figure 12 shows the VLAN dialog setup of the IP configuration tool. The VLAN implementation is me

V4.5 www.westermo.com U/R/T200 series - 32 - - A trunk port will be member of all "Standard VLANs" and " Additional VLANs "

V4.5 www.westermo.com U/R/T200 series - 33 - 12 Time synchronization Variable latencies through the protocol stacks and the Ethernet switches

V4.5 www.westermo.com U/R/T200 series - 34 - The CPU handles the time sync protocol, T200 configuration via e.g. SNMP, serial interface versus

V4.5 www.westermo.com U/R/T200 series - 35 - achieved if time stamping on the client is performed in hardware. Westermo OnTime networks provide

V4.5 www.westermo.com U/R/T200 series - 36 - load dependable latency through off-the-shelf Ethernet switches without any time sync support will

V4.5 www.westermo.com U/R/T200 series - 37 - the corresponding DELAY_RESP packet is then modified with this measured delay. The sequenceId is

V4.5 www.westermo.com U/R/T200 series - 38 - - Peer-to-Peer (P2P) propagation delay measurement E2E according to IEEE1588 version 2 is based

V4.5 www.westermo.com U/R/T200 series - 39 - The UTC format is as follows: • output UTC • transmission every second • transmission with contr

V4.5 www.westermo.com U/R/T200 series - 4 - 1 Introduction This Operator Manual describes the properties of the T200, R200 and U200 series.

V4.5 www.westermo.com U/R/T200 series - 40 - C D E F x 1 0 0x 1 0 1x 1 1 0x 1 1 1 Thursday Friday Saturday Sunday The status byte is output as

V4.5 www.westermo.com U/R/T200 series - 41 - A network where time synchronization is both based on time synchronization via the Ethernet and t

V4.5 www.westermo.com U/R/T200 series - 42 - 12.7 Pulse Per X seconds on GPS interface Two PPX copper output signal can be generated on the

V4.5 www.westermo.com U/R/T200 series - 43 - serial interface (where NMEA reports are received). This GPS receiver/antenna is shown below:

V4.5 www.westermo.com U/R/T200 series - 44 - Figure 20, Network and time synchronization redundancy 1

V4.5 www.westermo.com U/R/T200 series - 45 - Figure 21, Network and time synchronization redundancy 2

V4.5 www.westermo.com U/R/T200 series - 46 - 13 Switch Technical Specification 13.1 Interface Specifications RJ-45 Ports 10/100BASE-TX

V4.5 www.westermo.com U/R/T200 series - 47 - 13.4 Environmental Specification Indoor use or corresponding environment Altitude up to 2000M O

V4.5 www.westermo.com U/R/T200 series - 48 - Signal 1kV/- Voltage Dips Voltage Interruptions EN 61000-4-11 for AC Supply Conduced RF

V4.5 www.westermo.com U/R/T200 series - 5 - 2 About Westermo OnTime 2.1 Company History Westermo OnTime is dedicated to the implementation o

V4.5 www.westermo.com U/R/T200 series - 6 - 3 Ethernet – Industrial Ethernet 3.1 History of Ethernet In late 1972, Metcalfe and his Xerox P

V4.5 www.westermo.com U/R/T200 series - 7 - However, the domain of Ethernet has always been controlled by the IT department who configured offi

V4.5 www.westermo.com U/R/T200 series - 8 - • Only one system is allowed to proceed with a transmission of a frame within a Collision Domain a

V4.5 www.westermo.com U/R/T200 series - 9 - 4 Switch Operation 4.1 Introduction A switch has to forward and receive packets from one LAN or d